Hit enter after type your search item

Projection Alarm Clock with Backlight

/
You are Reading..

Projection Alarm Clock with Backlight

  • Projects time and outdoor temperature (alternating) on wall or ceiling in easy to read numbers
  • Wireless IN/OUT temperature (F/C)
  • Atomic self-set time and date with automatic reset for Daylight saving time
  • Calendar display
  • Projects time and outdoor temperature (alternating) on wall or ceiling in easy to read numbers
  • Wireless IN / OUT temperature (F/C)
  • Atomic self-set time and date with automatic reset for Daylight saving time
  • Calendar display

See your outdoor temperature before you get out of bed. Projection views on a ceiling or wall. Featuring temp & time, along with moon phase. Uses included AC adapter, but requires battery backup of 3 AAA batteries (not included.) Included weather resistant wireless outdoor sensor (2 AAA batteries not included.).

STEP 1:
• Insert the 5 volt AC power adapter into the designated area on the back of the Projection Alarm.
• Insert the power adapter plug into a wall outlet for a continuous backlight and projection.
• The Projection Alarm will light up and display indoor temperature, time (12:00) and date (1/1 FRI).
IMPORTANT: When operating on a/c power, to avoid interference, the projection will turn off while the Projection Alarm searches for the WWVB signal. The projection will return after the 2-10 minute search.

STEP 2: (optional battery operation)
• Remove battery cover from the bottom of the Projection Alarm, slide tab and pull out to remove the cover.
• Insert 3 NEW AAA batteries (not included) into the Projection Alarm. Observe the correct polarity (see marking inside the battery compartment).
• Do NOT mix old and new batteries.
• Do Not Mix Alkaline, Standard, Lithium or Rechargeable Batteries
• The Projection Alarm will light up and display indoor temperature, time (12:00) and date (1/1 FRI).

STEP 3:
• Keep the transmitter within 10 feet of the Projection Alarm during setup.
• Remove battery cover from the TX141 transmitter: Slide the battery cover down and lift off the front.
• Insert 2 NEW AA batteries into the transmitter. Observe the correct polarity.
• Keep the Projection Alarm and the transmitter close to each other (within 10 feet).
• Within 3 minutes the Projection Alarm will display readings in the outside temperature area

TROUBLE SHOOTING:
1.    After 3 minutes, if the Projection Alarm does not display the outdoor temperature,remove the a/c power adapter and all batteries from both units and start the setup process again.
2.    If the outdoor temperature does not show up after a second attempt, please slide open the battery cover of the outdoor transmitter to reveal the TX button. Push down on the TX button for 3 seconds to send a wireless signal to the Projection Alarm.
3.    Hold the +/TEMP button and the Projection Alarm will search for the transmitter.
4.    For optimal 433 MHz reception, the outdoor transmitter should be placed within 200 feet (60 meters) from the Projection Alarm.